Farmcoat Epoxy Mortar

Do you have small or large holes in your floor or wall? Does your concrete need to be repaired, filled or raised? Then use Farmcoat Epoxy Mortar. This mortar is waterproof, very high wear resistance and can be applied in very thick layers (up to about 10 cm).

Farmcoat Epoxy Mortar is available as a 2.5 Kg set or a 20 Kg set. 

• Very hard and wear-resistant
• Waterproof
• Good filling and sandability
• Paintable
• Use on wood, steel, concrete and other mineral substrates.

The mortar consists of:

• Farmcoat Epoxy Resin (Resin+hardener)
• Farmcoat mortar filler sand

Mixing ratio and consumption: The amount of sand dosage can be adjusted according to your own requirements.

Recommendation as raising casting compound: 20KG set - Combine the 5.15 Kg resin with 10-12 kg Farmcoat Mortar sand (approx. 3/4 of total amount of sand). You will then have a total of 15-17 Kg of ready-to-use mortar (approx. 8 Liter).

Recommendation as a filling repair mortar: 20KG set - Combine the 5.15 Kg of resin with the total 14.85 Kg of Farmcoat Mortar sand. You will then have a total of 20 Kg of ready-to-use mortar (approx. 10 liters).

Method: First mix the components of the resin. Then dosedly mix in the sand mix using a mixer on a drill. If you have a large quantity, do this in e.g. a mortar tub or sturdy large bucket. Mix it until you have an even mass. Process the mortar mix with a putty knife, hand trowel or flat trowel. We recommend using a mixer with a larger head for large quantities.

Processing time mortar mix: about 60 minutes (after 60 minutes it slowly thickens)

Cured/loadable after about 12 hours at 20 degrees.

The substrate must be clean, dry and sound. Loose and brittle concrete pieces and/or old loose coating pieces must be removed.